Hand Held Launcher
Loading time = 60 seconds or less
Pictured above is our 20" Celebration Launcher, 8 gram Co2, &
20" sleeve of rainbow streamers.
to view Demo
Follow these easy steps to properly load our
20", 32"or Electric Celebration Launcher with confetti and/or streamers.
If you want to launch your own custom color
combos, simply buy sleeves of the solid colors you want. For example; your
school colors are black, yellow, and white, simply load the launcher with 1/3 of
Step 1) Using a pair of scissors, snip open the sleeve of
confetti or streamers making sure the opening is wide.
Step 2) Insert the open sleeve into the launcher 3-4
Step 3) Firmly grasp the launcher and sleeve of paper.
Step 4) Flip the launcher and sleeve over allowing the
paper to fall from the sleeve into the launcher.
Be careful the sleeve does not fall out of the
launcher! If you wish to mix streamers and confetti into the same launcher,
or are mixing colors, pinch off the sleeve holding back what you do not want
in the launcher.
Step 5) Remove the empty or partially used sleeve. You may
use scotch tape over the end of the tube to keep the paper from falling out
during transport. No need to remove the tape, the paper will blast through the
tape. Note: Do not transport with Co2 screwed in. Screw in Co2
just before use.
Step 6) Make sure the lever is in the up and closed
Step 7) When ready to use, screw in 1 warm 8 gram Co2 cylinder. Do not over
tighten. Do not transport with Co2 in place.
Step 8) Firmly hold cannon as shown, away from your body. Aim where you want to
shoot. Quickly pull on red ball and string being careful not to move the end of
the launcher from your targeted location.
Step 9) Remove and discard the used Co2 cylinder. Replace
the lever back in the up and closed position.
READ AND OBEY THE SAFETY PRECAUTIONS