Confetti & Streamer Launcher quick loading instructions.

Loading time = 60 seconds or less

Pictured above is our 20" Celebration Launcher, 8 gram Co2, & 20" sleeve of rainbow streamers.

Follow these easy steps to properly load our 20", 32"or Electric Celebration Launcher with confetti and/or streamers.

If you want to launch your own custom color combos, simply buy sleeves of the solid colors you want. For example; your school colors are black, gold, and white, simply load the launcher with 1/3 of each color.

Step 1) Using a pair of scissors, snip open the sleeve of confetti or streamers making sure the opening is wide.

Step 2) Insert the open sleeve into the launcher 3-4 inches.

Step 3) Firmly grasp the launcher and sleeve of paper.

Step 4) Flip the launcher and sleeve over allowing the paper to fall from the sleeve into the launcher.

Be careful the sleeve does not fall out of the launcher! If you wish to mix streamers and confetti into the same launcher, or are mixing colors, pinch off the sleeve holding back what you do not want in the launcher.

Step 5) Remove the empty or partially used sleeve. You may use scotch tape over the end of the tube to keep the paper from falling out during transport. No need to remove the tape, the paper will blast through the tape. Note: Do not transport with Co2 screwed in. Screw in Co2 just before use.

Step 6) Make sure the lever is in the up and closed position.

Step 7) When ready to use, screw in 1 warm 8 gram Co2 cylinder. Do not over tighten. Do not transport with Co2 in place.

Step 8) Firmly hold cannon as shown, away from your body. Aim where you want to shoot. Quickly pull on red ball and string being careful not to move the end of the launcher from your targeted location.

Step 9) Remove and discard the used Co2 cylinder. Replace the lever back in the up and closed position.

Confetti Launcher and Paper Ordering Page

SAFETY PRECAUTIONS

1.      Do not operate if the launcher is damaged in any way.

2.      This is a high-pressure projectile launching system. Do not point it at anyone or any thing.

3.      This system should not be used by anyone under legal age or under the influence of alcohol or drugs.

4.      Complete every step described in the label instructions before using.

5.      Be sure the launcher tube is empty before loading any streamers or confetti. Use only approved products.

6.      Remove any outer wrappings from streamers and/or confetti before launching.

7.      Do not attempt to disassemble any part of this product.

8.      Stay alert and use common sense when using this or any effect.

9.      Avoid shooting streamers or confetti on or around any high power electrical cables.

10.  Keep this device away from children. This is not a toy!

11.  Assume full responsibility before using this effect. Do not use if you are under the influence of any drugs or alcohol.

12.  Avoid knocking anything loose over head or in the path of the streamers or confetti including ceiling fans. Allow at least 50 feet of clearance in the direction that the launcher points.

13.  Do not point or activate launcher towards any person or objects that may be damaged from the projectile effects.

14. Do not transport with Co2 screwed in place.

15.  A Class Act, S.E.I. Inc., it's agents, employees, and sales personal will not be held liable for any damages to persons or properties that might arise from the improper use or misuse of this or any product purchased from us.

A Class Act

609-660-7788

800-499-3433

Box 348

Waretown, NJ, U.S.A., 08758

Email: fx@aclassactfx.com

Home page www.aclassactfx.com